Automotive Carpet for 1982-1988 Chevrolet Monte Carlo 2-Door (Black Plush Cut Pile)

This automotive carpet will be available in 801-Black Plush Cut Pile. Other colors and materials may be offered in the selection above. This aftermarket carpet is a replacement for the 1982 to 1988 Chevrolet Monte Carlo, 2-Door model.

The carpet will be manufactured with a standard flexible polyethylene backing. Customers can contact us to upgrade to a mass-backed option. Unless specified, the jute padding will be pre-attached in the foot area of the carpet.

Installation may require trimming around the edges, and holes may need to be cut. A wide variety of colors are available, and customers are encouraged to request free samples if they wish to match a specific color.

This item fits the following model years: 1982, 1983, 1984, 1985, 1986, 1987, 1988, as well as the shortened designations 82, 83, 84, 85, 86, 87, and 88.

Before beginning the installation, please read the full instructions carefully, as they may vary for multi-piece sets.

1. Unpack the new product, lay it flat, and allow it to relax for a few hours to regain its proper shape. Inspect the material for accuracy.
2. Compare the new carpet to the old one.
3. It may be necessary to use the old carpet as a template for cutting console openings.
4. Fold the new product in half from front to rear, and place it in the vehicle, aligning the molded contour to the seat risers or any other identifiable starting point on both the driver and passenger sides. Once fitted, continue the installation.
5. Roll the product forward and make cuts for brackets, shifters, vents, etc., while maintaining proper alignment on the seat risers or other starting point.
6. Cut the product in the center at the firewall to allow it to go underneath the dash.
7. Repeat the same procedure for the remainder of the installation, working your way to the outer edges.
8. Once the product is properly fitted, you are now ready to do the final trimmings on the outer edges, seat belts, and holes.

Note: If adhesive is desired, only apply a light brush or spray adhesive after the correct dry fit has been obtained.

This item is made in 801-Black Plush Cut Pile carpet. The item image may be a different color, but the SWATCH image is the correct color. The carpet is designed for a 2-Door model. Unless otherwise noted, the jute padding is heat-bonded to the backside of the carpet, and a heel pad is welded to the correct location.

Holes may not be pre-cut in the automotive carpet, and the carpet may require trimming to install. Please refer to the installation instructions on the Help tab in our store details page.

product information: